1.Tenyu TCT Circular saw blades are designed with TCG teeth, suitable for ripping cut and cross-cutting hardwood plywood and laminates panels, as well as single-sided veneered or plastic-coated board.

2.Triple chip grind (TCG) tooth geometry – designed for delivering maximum performance and high quality of finishing in highly abrasive materials.regardless of the frequent use for hard plastics, composite materials like melamine, laminate, MDF, non-ferrous metals like aluminum, copper, bronze and the other tough metals.

3. Tungsten carbide teeth provide excellent wear and heat resistance. the positive cutting angle which provides fast and efficient removal of chips and swarf.

4. Fully hardened steel blade body – delivers accuracy and resists bending and deflection for true cuts.

5. Heat expansion slots allow the blade rim to expand and contract without warping for straight and accurate cuts.

6.Equipment used with Circular Saw, Miter Saw, Table Saw, Radial Arm Saw, etc

How to Use:

■ Follow carefully the instructions given in the machine handbook.
■ Never fit a diamond dish/cup wheel which is too loose or too tight on the flange.
■ Tighten only with the tool supplied with the machine.
■ Ensure the wheel is properly gripped to prevent slippage, but do not tighten with excessive force. Never use a hammer.
■ Keep flanges and screw threads clean and free of burrs and rust.
■ Replace distorted or damaged flanges before fitting the wheel.

For your Safety:

We recommends the use of following personal protective equipment:

■ Eye protection
■ Ear protection (ear sets)
■ Hand protection (gloves)
■ Lung protection (dust mask, also called respirator)

Important Note:

Never remove the protective machine guard and make sure it is properly adjusted to deflect debris away from you.
Ensure that no other person is at risk, especially near the machine while working.