1. Expert Quality, manufactured from 45# special carbon steel hardened and tempered.
2. Full-length heat treatment guards against bending bit in heavy-duty applications.
3. The precision ground central point with optimized design for faster cutting performance.
4. Double cutting spurs scribe the outside of the hole reducing breakout.
5. Quick-change shank reduces slipping in standard chucks and is compatible with all 1/4″ quick-change chucks and Extension, including impact drills.
6. Designed to perform fast, clean cuts, will bore all types of timber and are equally efficient when drilling with or against the grain.
7. Hang hole allows for bit storage & wire pulling
How to Use:
■ Follow carefully the instructions given in the machine handbook.
■ Never fit a diamond dish/cup wheel which is too loose or too tight on the flange.
■ Tighten only with the tool supplied with the machine.
■ Ensure the wheel is properly gripped to prevent slippage, but do not tighten with excessive force. Never use a hammer.
■ Keep flanges and screw threads clean and free of burrs and rust.
■ Replace distorted or damaged flanges before fitting the wheel.
For your Safety:
We recommends the use of following personal protective equipment:
■ Eye protection
■ Ear protection (ear sets)
■ Hand protection (gloves)
■ Lung protection (dust mask, also called respirator)
Important Note:
Never remove the protective machine guard and make sure it is properly adjusted to deflect debris away from you.
Ensure that no other person is at risk, especially near the machine while working.